Home/Products/Building Wire Extrusion Line

Building Wire Extrusion Lines for Insulation Production

Compare building wire insulation line configurations, then send your cable size, material, structure and output target for an engineering review.

How to select a building wire extrusion line

The right configuration depends on the cable specification and factory conditions. These four inputs help narrow the line route before a technical proposal is prepared.

Cable construction and standard

Identify the building wire type, applicable standard and whether the required insulation structure is single-layer or uses multiple extruders.

Size range and material

Provide the conductor size, finished diameter range and insulation material so the extrusion and tooling route can be reviewed.

Output and quality target

State the required speed or output together with the dimensional, surface and inspection requirements used for acceptance.

Layout and reel handling

Share the available floor length, reel sizes and preferred payoff and take-up arrangement so the complete line can fit the production area.

Typical complete-line scope

Depending on the submitted specification, the line scope is coordinated across payoff and wire handling, extrusion and tooling, cooling, measurement and control, pulling, and take-up. The final equipment list is confirmed against the cable and factory requirements rather than assumed from a standard layout.

What this line is built for

Golden building wire extrusion lines are designed for insulation production on common building and installation wire applications. The line can be configured around customer cable structure, factory layout and downstream handling requirements.

  • Building wire high-speed insulation production.
  • Single-layer and multi-extruder line configurations where the cable structure requires it.
  • Projects that need practical customization, pre-shipment testing and a clear model match before quotation.

Related models

Building wire line selection questions

Use the model links as a starting point. The final recommendation is based on the submitted cable specification and production plan.

Can one standard line cover every building wire?

No single configuration should be assumed to cover every construction. Cable size, insulation structure, material and production target must be reviewed together.

When is a multi-extruder route considered?

It is considered when the required cable structure calls for multiple extrusion layers or process stages. The submitted cable drawing determines whether that route is appropriate.

How is the quotation scope confirmed?

Golden Technologies reviews the cable, output target, factory constraints and test requirements before confirming the proposed line configuration.

What to send us for quotation

  • Cable type and applicable standard.
  • Material, conductor size and insulation structure.
  • Required speed or output target.
  • Existing factory layout or new project plan.
Request line configuration Send us your cable specification